|We had to try a couple of different methods to pull the railing up.|
We first tried using 1/8" AC Cable. This didn't work as we wished. (we also ran a little short.) So, we switched to black tie line. This proved to work very well. Tie line does stretch and we were able to adjust the lines as needed.
The outer pulleys are covered. Why? The tie line kept slipping off. The plywood locked the tie line in place.
|These pulleys are screwed into the floor with 1 1/2" drywall screws. Using these small pulleys allowed us to direct the tie line in any diredtion needed|
|Take a close look at the middle photo. You'll see that the tie line changes direction. First passing through the horizontal pulleys, then down over the vertical one.|
|The tie line travels down the post casing and runs under the large pulley at the base of each post.|
|The case is larger then the posts to allow the tie line to travel. Small spacers are placed to guide the post up & down in a straight line.|
|An access panel was cut at the bottom of each case. This allowed for quick re-threading of the tie line as needed.|
|We had to maintain constant tension on the line. If not, the line would fall off anyone of the pulleys. That was a pain!|
|This use of rope and pulleys is not limited to railings! How many things could you do, by remote control, with tie line?
Off the top of my head, some ideas: move stage pieces without being seen, open or close windows &/or curtains during quick blackouts, and more.